KATRIX DRIVE   /   ACTUATOR CONTROL

Command motion.
Shape the pulse.

Actuator control engineering for CAN-connected machines. Define the outputs, command behaviour and bench tests for your next prototype.

Explore the architecture
PWM EXPLORERSimulation
ARCHITECTURE

From CAN command to actuator

A six-channel PWM controller concept forms the starting point. Electrical ratings, feedback and protection depend on the selected load.

CAN · Command interface

Command mapping

Define channel assignments, command scaling and the response to a missing message.

Vehicle integration
PWM · Six-channel concept

Output control

Match each output to the load, supply voltage, current demand and switching frequency.

Electrical design
TEST · Project-specific

Bench validation

Exercise representative loads and record output response, temperature and fault behaviour.

Prototype evaluation
APPLICATIONS

What do you need to control?

Mobile machinery

Map machine commands to proportional actuators. Specify the vehicle bus, supply transients and required response after a communications timeout.

Valve actuation

Characterise a solenoid or proportional valve across its operating range. Supply coil resistance, inductance and the target current profile.

Hardware test benches

Exercise several loads from scripted CAN commands. Define which timing and electrical measurements will determine acceptance.

PROJECT ENQUIRY

Scope your pilot

Outline your application to request an engineering quotation. You can review the draft in your email app before sending.